How To Make Cold Process Soap Embeds Tutorial

Most Recent

I found some really economically priced silicone ice cube
moulds in the shapes of small butterflies, only $2.00 per mould with 13
small butterflies to each mould. My fertile mind began to kick in and I
thought these would like nice in a bar of soap so I purchased a few of them
to make up this tutorial.

embeds1

I got to work and made up some un-fragranced cold process
(CP) soap. I used 5 colors which I thought would compliment each other
while set in a base of white CP. The butterflies are approximately 30mm X
20mm

Here you can see the different colors in the silicone
moulds waiting to set.

embeds2

The soaps popped out easily enough and I had planned on
using my soap planer to slice them into thin slivers but the soap was too
fresh and they were curling up so I used one of my small paring knives with
a thin blade to slice them up by hand. They then kept their flat shape even
if they were a little thicker than I had anticipated.

I let them dry out for week.

embeds3

All ingredients ready to go, along with the sliced up
butterflies.

embeds4

The soap is now at 'trace' ready for the addition of the
butterflies.

embeds5

I fragranced the CP soap and added the butterflies. I
realized I could have had had more butterflies in the amount of CP I made
up. Its amazing just how much of the re-batched butterflies you can fit into
a small amount of CP.

embeds6

The mix was poured into the mould box and using a gloved
hand :-) I poked the butterflies down to the bottom of the mould box so they
would be flat as I didn't have enough of the butterflies cut to give a good
solid filling so to make sure I had at least one good solid covering of the
butterflies I pushed them to the base.

embeds7

You can see how bare the surface looks after unmolding.

embeds8

The base is a different story :-) Pushing them into the by
hand has paid off!
Now they are ready to push out of the cavities.

embeds9

The finished bars turned out just as I had visualized them
in my head.

embeds_10

Tutorial Provided by Terry "Nizzy"
Nisbet Owner and Operator of Nizzy
Molds
Please visit her site and show your support!

The copyright of the images displayed
within this website pages are owned by Nizzy Productions©.
You may not, download, manipulate, print, reproduce or share any of these
digital images, in part of or in whole, unless authorized by written license
issued by Nizzy Productions©

Rate: 
Average: 4 (1 vote)
Add This: